Interested to Buy Any Domain ? << Click Here >> for more details...
A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
- 20 Answers
- 23385 Views
- I also Faced
- E-Mail Answers
Answer Posted / vasuram
it acts as a transformer
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
What is Fire Panel ? How it works ?
Why line VTG = √3 phase VTG in star? How?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What is MS-EXCELL?
Difference between earthing & grounding.?
How to calulate Locked rotor amper(LRA) for compressor type motors?
What are the specifications for conducting earth leakage test as per IEC standard?
What is negative sequence over voltage element?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
what is meant by motor startup supervision & motor load jam protection ?
what is difference between cpp electrical system and refinery electrical system
