Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 357841 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / ashok kumar gc
Electrical deals with genration, transmission & utilization
of electric power
where as electronics is deal with microcurrents to transfer
the data or switch on the devices..etc
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
what about GD square and its important for motor design?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
Can anyone tell the proper diagram of star delta starter????
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
What is the ratio of Booster transformer?
i have a 1500kVA transformer what is the kWH meter i need to use?
What is a slack bus?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
How to run a three phase motor into single phase........
is oil viscosity affect on motor current?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
What is Instantaneous Earth fault relay,how will work
what is meaning of bus riser
