what we happen if 400 kvar cpacitor banks are on in manual
mode and there is no load on mains ??????????????
- 7 Answers
- 8819 Views
- HCL, Reliance, I also Faced
- E-Mail Answers
Answer Posted / vinod sharma
If the bamk is on mannual it will lead the voltage.
Due to this the power factor will cross the limit 1 and
with this losses will increase.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
The electromagnetic torque developed is proportional to what in a D.C series motor?
What is the effect of pi controller on the system performance?
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
What are different types of control systems?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
full form of electrical?
What is the formula to calculate the rating of a three phase air circuit breaker
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
do you have some of interview Questions in power and genrator section in general whith answers
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
if sf6 gas low in gis what will happen
