Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of starter in tube light?and what it
contains
- 12 Answers
- 50091 Views
- L&T, RRB, I also Faced
- E-Mail Answers
Answer Posted / dharma
it to increse starting current , it require for tube lite
for initial. it contain bi-matalic strip.capacitor is also
connected for improveing power factor.
| Is This Answer Correct ? | 49 Yes | 27 No |
Post New Answer View All Answers
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
model question paper for supervisor trainee
what is thermal resistance of PVC Cable.
Form S and "c" license application both are same? @ tneb portal
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What are the classifications of oscillators?
how to select proper cable for ct wiring so that drop within the limit.
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
what is PDU in transformer?? which company manufacture??
what will happen if there is a voltage leakage or current leakage in an electrical train
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
How many methods use the load flow solution?
What is limitedly stable system?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
