Interested to Buy Any Domain ? << Click Here >> for more details...
three phase 180kva diesel generator can take how much load
in amp and what is formula to get this?
- 13 Answers
- 62605 Views
- lenovo, I also Faced
- E-Mail Answers
Answer Posted / ahmed umar
Since the Genset Rating is given in KVA as 180KVA.
I think you should calculate the full load Amperage as
follows:
Formula
I=KVAx1000/Root3x400V
ie, 180x1000/1.732(400)
=180,000/692.82
=259A as full load Amperage.
| Is This Answer Correct ? | 13 Yes | 7 No |
Post New Answer View All Answers
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
What is Fire Panel ? How it works ?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
work of choke in florocent tube circuit ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
along with technical test papers
What is the vector group of a transformer,how can it be found out?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
how we calculate the short circuit capacity of the busbar in LV & HT?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
What is the Current equation in series RLC circuits.
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
EXPLAIN THE ESSENTIAL FACTORS WHICH INFLUENCES THE CHOICE OF SITE FOR A HYDRO ELECTRIC POWER PLANT
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
