why does chattering take place in ac contactors?
can it be avoided & what care does the manufacturer take to
eliminate this phenomenon????
- 10 Answers
- 53154 Views
- I also Faced
- E-Mail Answers
Answer Posted / srij21
Apart from the above correct answer,chattering may happen
aslo due to the loose supply wire given to the contactor
coil and also on the coils magnetic effect.
| Is This Answer Correct ? | 28 Yes | 11 No |
Post New Answer View All Answers
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
What is order of the system?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
why a tester wont shock while testing the power in house
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
What does ampere turns shows?
what about electrical pannel.? What is meant by plc pannel.?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
What is the estimated total hydropower potential of india?
what is PID control in VFD drives?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
