Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the 3ph capacitor is good or not.
- 14 Answers
- 59483 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / robert harper (ee tech)
My non fail proof but handy way is to remove the cap. from
the circuit and connect your VOM to the terminals and watch
the voltage dissipate. The set the VOM to Ohms and
reconnect the meter to the cap. and you should see the
resistance steadily go up close to infinity. You are
actually charging the cap. with the battery in the VOM.
Then recheck the voltage and you should have a low charge
and then it will dissipate again. Good cap. via non fail
proof test.
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
What are the types of instrument transformer?
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
I completed iti in2004 I was worked in A grade contractor can I get c licence
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
why we used ZNO in Lightning arrester.
what are the application of over current relay?
When are the directional relays used?
Installation method of self treated earth electrode.
Why two phase welding machine is used instead of three phase welding machine.
is IS says that neutral should be brought to switch box. and this one is a recomended practice
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to calculate transformer load?
operation of protection relay watchdog contact?
