Interested to Buy Any Domain ? << Click Here >> for more details...
what is the suitable voltage of transmission line to
transmit 10000w power through 250 km.
(a)11kv
(b)33kv
(c)66kv
(d)132kv
]and please tell me whats the logic behind it
- 7 Answers
- 20996 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / rod
The higher the voltage the greater the distance as the
current is less but the power is the same. For very long
distances DC at very high voltage is used.
| Is This Answer Correct ? | 1 Yes | 9 No |
Post New Answer View All Answers
what is resver in electrical enginnering with answer
What are the characteristics of negative feedback?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
different aspects of voltage stability
Explain what is clipper and clamper circuits?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is class ab operation?
single phase power supply give to separate one steel coup with water, what reaction create
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
what is allowable ac mixing in dc
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
What is resolution of a measurement?
