Interested to Buy Any Domain ? << Click Here >> for more details...
which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 20763 Views
- I also Faced
- E-Mail Answers
Answer Posted / debashisdb
dc is more cost effective for the reasons mentioned above.
ac is used since ac-dc conversion was very expensive
earlier. but now with development of hvdc transmission &
semiconductor technology it has become quite cheap. however
it is difficult to change and re-install the already
existing systems in such a large nation like india.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
Why we cant store an ac power. If we coo store in which device we can?
What is difference between Over Current & Earth Fault protection?
What is the magnetic field (coil DC ) of Turbo Expander?
Why the output of OP-AMP is always less than Vcc?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
how to calculate earth fault relay current and CBCT ratio
What is the difference between line drop and percentage line drop?
hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
How to assume answer to electrical questions
What is pi controller?
What is the Minimum winding resistance of motors ( small & big)? referance range
Which do you think is the most significant cause of energy loss in a factory?
