Answer Posted / nipuna

Problems will occur in the following areas if the base band
signal(information signal)is transmitted as it is,without
modulation.
1.Antenna Height
2.Narrow Banding
3.Poor radiation and penetration
4.Diffraction angle
5.Multiplexing

So Modulation is necessary for the transmission of low
frequency information signal from one site to another in
good quality.

Define nyquist criteria.

1121

---

What is tristor?

1136

---

Water boiling point temperature is 100 deg. In which liquid state is convert into the gas state,but in turbine which principle is use by which exhaust temperature is 50-55 deg and is in the stage of steam?

1210

---

Define hard-driving or over-driving?

1213

---

What is modulation? And where it is utilized?

1238

---

what is the use of FR-4(flame retardant)in PCB design why dielectric material used in inner layer in PCB design technology??

2126

---

What is a waveform used for in reference to electronics?

1194

---

Explain what is the difference between plc and dcs?

1078

---

Draw a schematic diagram of a Half Adder. Can you draw the same using only NAND gates?

1144

---

describe the functioning of parallel adder ? what are the adventages of parallel adder over series adder?

2383

---

What are the types of commutation with respect to commutation process?

1130

---

Compare csi and vsi?

1393

---

Explain is rfid in developing stage? What is scope in rfid?

3495

---

needed web address and its directory for objective type question with answer in electronics instrumentation paper.

3276

---

what is the ideal resistanceearth and why?????????????

2020

---