Interested to Buy Any Domain ? << Click Here >> for more details...
Which pump set is more suitable and economical for
liftingwater from 300Mtr borewell?
A. Compressor Pump
B. Submersible Pump
C. Jet Pumps
D. 25HP Centrifugal Pump
Q. from PSC Test 22-11-2008 Meter reader
- 8 Answers
- 24386 Views
- I also Faced
- E-Mail Answers
Answer Posted / sushendra mishra
submersible pump
| Is This Answer Correct ? | 26 Yes | 1 No |
Post New Answer View All Answers
briefly explain principle of resistance welding
What is the difference between DOL starter and star delta starter
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
State kirchoff current law?
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
Why synchronous motor is used in power factor improvement,dc series in lift
How shall i select the value of capacitor or inductor in a system?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
hello if any one have papers vof hpcl or sail, plz send me
who can measure the size of power cable?
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
