Interested to Buy Any Domain ? << Click Here >> for more details...
On what basis no of earth pits are to be decided either for
transformers or for equipment?
- 8 Answers
- 22886 Views
- BEL, Reliance, I also Faced
- E-Mail Answers
Answer Posted / sathihsa
earth pits for tr depends on kva rating and fault current
use to carry.........
| Is This Answer Correct ? | 9 Yes | 17 No |
Post New Answer View All Answers
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
why we use single core 630mm2 cable for transformer secondary side
Why we cant store an ac power. If we coo store in which device we can?
BSNL TTA EXAM QUESTION
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
Why PS class CT is always preferred for Differential protection?
Explain difference between stand by earth fault and residual earth fault protection?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
How to calculate the heat load for a electrical room
