Interested to Buy Any Domain ? << Click Here >> for more details...
why we give clock rate to DCE and not to DTE
what is the difference in the two.
- 3 Answers
- 27335 Views
- I also Faced
- E-Mail Answers
Answer Posted / naveen kumar sharma
Because DTE basically contained the router serial interface
and DCE contained the isp router end ,and two dte cannot
communicate directly atleast one DCE would be there for
communication,and dce provide clocking for
synchronization,thats why we use back to back serial cable
in industry its one end behave as DTE and its other end
behave as DCE.
| Is This Answer Correct ? | 52 Yes | 14 No |
Post New Answer View All Answers
Why we used Virtual MAC in GLBP
Differentiate full-duplex from half-duplex.
What is syntax of ipv4?
Tell me which cable called roll-over?
Explain which layer are called upper layer?
What is a Window in networking terms?
What is the size of ipv6?
State the difference between dynamic IP and static IP addressing?
What are the things that can be accessed in a CISCO router’s identifying information?
What is hsrp?
What is an autonomous system?
Name the protocol which can do load balancing on unequal cost also?
what does PPTP use for encryption and authentication?
In eigrp metric parameters which 2 options are enable by default?
Explain the difference between bus topology and hub?
