Interested to Buy Any Domain ? << Click Here >> for more details...
I HAVE CONSUMER WHOSE POWER FACTOR IS 65% I WANT TO INCREASE
IT TO 98%.HOW TO CARRY OUT?
- 7 Answers
- 9554 Views
- I also Faced
- E-Mail Answers
Answer Posted / e.saravanan
PROVIDE YOUR LOAD IS VERY USEFUL FOR FINDING OUT
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
physical identification of HT & LT panel
what is cathodic protaction?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
what is W.T?specify the acceptable range?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
mccb service sittings be done?
.php|
how we design a pannel to start 10HP motor with the help of star delta starter?
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
SUTIABLE FOR ohm's law super conductor
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
