Interested to Buy Any Domain ? << Click Here >> for more details...
which starter is used for synchronous motor
- 18 Answers
- 26084 Views
- APTransco, IBM, I also Faced
- E-Mail Answers
Answer Posted / moti rgpv
DOL is also correct BUT IT IS NOT WIDELY USE FOR LARGE
RATING FOR SYN. MOTOR.
SO IN OPCTION DOL IS WRITE
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
why magnetising curve not start with zero voltage?
Give atleast 20 alternating current apparatus and devices.
where can the transformer having vector group Yny0 be used??
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
How dia computation perfomed in cold rolling mills .
How do you compute voltage drop and cable size over distance?
why industry prefer ht motor instead of lt motor.
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
Efficient electrical earthing in hard rock area
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
What is the classification of hydro projects based on installed capacity?
