which starter is used for synchronous motor
Answer Posted / moti rgpv
1-:STAR -DELTA STARTOR
2-:COUPLING WITH INDUCTION MOTOR AND REMOVE THE MOTOR
AFTER GETING 80% TO 90% OF SYNCHRONOUS SPEED
3-:USING DAMPER BARS
| Is This Answer Correct ? | 48 Yes | 7 No |
Post New Answer View All Answers
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
what is EIB lighting control system? what is the advantages of this system?
what is meaning of bus riser
Is RTCC panel needs any control supply.
how we design a pannel to start 10HP motor with the help of star delta starter?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
Why ground terminal is used in pot meter 10k ohms
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
how to decide choke rating for drive?
What current flows in the transformer primary when its secondary is open?
Why are the laminations insulated from each other?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan