What is the difference between "Earthing" and "Neutral"?
- 10 Answers
- 13167 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / motilal sahu
EARTHING IS USE PATH FOR LEAKAGE CURRENT.
AND NEUTRAL IS FOR COMPLITE THE PATH OF ELECTRICAL CIRCUIT.
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
What is the function of RCBO? What are the different sensitivity ratings & each application?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What is the Nyquist criterion regarding control systems?
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
whatis the commertial spec. of distribution boards ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
how do you test tachos and servos
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
harmonics filter
What is PQA???Applications........
physical identification of HT & LT panel
what is the difference between gas group b and gas group c electrical equipment construction wise?
what happens to the supply voltage if there is any change in frequency?
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
