Interested to Buy Any Domain ? << Click Here >> for more details...
Two electronic energy meters are connected to seperate
phase wires, but connected to a looped neutral. Are these
going to function correctly?
- 8 Answers
- 13855 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / dilip kumar
ofcourse both will work satisfactorily ,but if the
connection is used for measurement of 3-phase power then it
will nither give the correct power nor the correct phase
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
why we change the direction of winding in rotor ?how we make the north and south pole?
what parameters should we check to reduce the power bill
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
Difference between rating factor of cable and derating factor of cable?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
What is the purpose of stablization resistor in high impedance bus bar protection
describe the phenomena of vacuum interruption in C.B
how does a liquid starter reduce the starting currents?
Which do you think is the most significant cause of energy loss in a factory?
If UG power cable both ends are to be earthed or what? If not why?
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
Details about Flux Compensated magnetic Amplifer starter for motors
Transmission through a short line depends on
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
