Answer Posted / sath
Normally MCB's are used for low voltage application.Phase
line is directly connected to the input pole of MCB.MCB's
are act as a contacter here.In normal operating condition
terminal of the MCB are closed position. if the current
value reach above the rated value then the conduct is open.
so there is no need for the relay here.
| Is This Answer Correct ? | 37 Yes | 12 No |
Post New Answer View All Answers
What is lifting power for 1 wb/m2 and 1 A magnet?
Define thermal resistance in the context of power amplifier.
wheather the size of windings in motor and generator are the same
star delta starter contorl circuit... drawing..
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
How do you compute voltage drop and cable size over distance?
for a 400kv t/m line with 10 ampere current will corona occur?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
What is the use of bundle conductors?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
How to decide DO set rating of Transformer?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
