Answer Posted / rafiq
calibration is nothing but the "testing" . it compares the
actual value to real value and realise that value takes the
decisions
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Make Heater Process Logic.
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
draw shematic diagram of c/v positioner(smart type)?
what is loop1 and loop2 in MTS LT?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
how to check earthing,what is minum ohms for proper earthing
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Can anyone send most commonly asked interview question in Oil & Gas industry
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
which type of zones used for boiler? & why ?
Where is wet leg is used?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
what is dc moter.
