I have recently seen a transformer which had two primary
terminals and was connected between two lines,i would like
to know what kind of transformer is it?short discription
about it,any advantages,purpose of usage of the
same.............
- 8 Answers
- 8723 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinothbabu.k
This type of Transformer will have two type of voltage
conversion..For example-440/230 & 440/110 or 440/230 &
230/110.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is motor capacity of 80TR chiller? and also say what is the formula related temperature, motor capacity, TR?
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
how does a submersible pump work..?
State The Difference Between Generator And Alternator?
what percent do you derate your copper wire when you change from copper buss to copper wire
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
can we install HT panel & LT panel side by side or how much clearance is required ?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What is Bolted fault?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
any application of back emf
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
which type of effect of turbine and generator reverse power protection ?
