Answer Posted / m.prabhakar
Depending up on the total load to select the dg.For example
180KW load is there 200kva capacity genarator is sufficient.
| Is This Answer Correct ? | 23 Yes | 29 No |
Post New Answer View All Answers
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
what is meant by 2 within a star in a voltmeter dial?
Which device is used for the source of emission of electrons in a crt?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
which is the best institute for PLC,SCADA,DCS in hyderabad
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
what is relay what is protection & contact multiplying relays where it is used function in brief
Why is the starting current high in dc motor?
what is the differences between microprocessor and general purpose computer
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
