Interested to Buy Any Domain ? << Click Here >> for more details...
I have recently seen a transformer which had two primary
terminals and was connected between two lines,i would like
to know what kind of transformer is it?short discription
about it,any advantages,purpose of usage of the
same.............
- 8 Answers
- 11033 Views
- I also Faced
- E-Mail Answers
Answer Posted / manjunatha
my it may be communication purpose were in 440v reciving
stations TO genarating station there is direct
communication line
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
Which type of questions well asked. ?
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
What is the function of the generator exciter?
Is it possible to connect a safety device in to parallel?
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
what are safety measures in /control in diesal engine/ explain them?
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
How the annunciator works ? How to do its wiring
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
