Answer Posted / krishna
Generator is the one which gives voltage as its output, by
having mechanical input.
For Eg: When the water falls on the panes fitted on the
shaft of motor the the force of the water results the shaft
to move and hence we have the current as its output.
( coil rotating in a magnetic field results in a current)
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what will be the min and max voltage flow from neutral to earth?
Is there any guideline say about display of earthing value near to earth pit
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
how give earthing conection to household equipment?
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
What is the working principle of MIG welding? and its out put Voltage?
how to calculate fault level?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
What must be the minimum distance maintained between 2 Generators as per International standards?
What is quadrantal symmetry?
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
