Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satish mankar
if,x'mer works in d.c supply,then flux is constant,no e.m.f
is produced,if back e.m.f does not produced the ckt will
draw a more current and causes heating of the winding and
x;mer will damage
| Is This Answer Correct ? | 12 Yes | 8 No |
Post New Answer View All Answers
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
What is different between Circuit breaker and Isolater?
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
What is an Air COmpressor
how to maintain frenquncy with syncronising sub-station for distribution
What is the high series capacitance winding on high voltage power transformer ?
What types of high speed CMOS circuits have you designed?
What is the function of the generator exciter?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
how to calculation increase capacitor,increase power factor for three phase.
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
What is the emf equation of a transformer?
