Interested to Buy Any Domain ? << Click Here >> for more details...
if HT side voltage is high current is low . and LT side
voltage is low current is high please explian.
- 5 Answers
- 23740 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / jital
Voltage & Current are the inverse propotion ( Voltage is
High, Current is less & Voltage is low, Current is More )
for the Same load when considered on different voltages.
its following P = VI
I.E> For the Same Load in 11 KV Current will be very less
For the same load in 415 V Current will be high compare to
11 Kv
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
What happens to a motor if it is connected in Delta connection
what is the importance of earthing system on the generators big capacity and small?
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
why not starting switch first connect in direct on line starter?????
what is the relative size of single and three phase?
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
Installation method of self treated earth electrode.
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
Why do we use copper cable for HT Supply and why not Aluminium?
why do we carry out winding resistance test?
what is the range of maximum DOL and SDS can be use for pump and fan application
