When you cords an IP address on a place router which command
stale the IP processing on the interface?
A. ip enable
B. network ip-address
C. ip address ip-address subnet mask
D. the exit command from the enabled configuration
E. copy running-configuration to startup-configuration
- 3 Answers
- 4953 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
ip address ip-address subnet mask
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which protocol works only on cisco routers?
Do we subletting of ip?
Explain the difference between named and extended acl?
How many valid ip will b in /21 in route summarization?
How many types of ospf configuration?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
What is the utility of ping?
What is protocol data unit in ccna?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is the difference between an igp and an egp?
What are the different types of network in ccna?
Explain what is the default behavior of access-list?
Explain how many ways to access router?
Explain the difference between tracert and traceroute?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
