Answer Posted / rvg
Power cable mainly intend to use transfer of power,
specifically current, over a defenite length.
According to the rating there will be change in the no. of
starnds etc for a.c.
control cables are mostly paired cables ,sometimes more
flexible than power cable. and are not intend to carry more
than 10A.(max.).
Is This Answer Correct ? | 39 Yes | 5 No |
Post New Answer View All Answers
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
Whether power factor should be high or low? Why?
rajha power sector details
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
can anyone give an idea about dia calculation in cold rolling mill
how to select automotive wire by mathematical equation with given current, vlotage and resistance
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
How to calculate earth wire load by formula
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Which capacitor is preferred for high voltage and frequency?
What is reactive power and where it is used.
I want to do a mini project. Now I'm studying in 6th semis tor EEE Engineering.
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience