why ammeter always connect in series for measuring the
current?
- 8 Answers
- 12082 Views
- I also Faced
- E-Mail Answers
Answer Posted / sandy
As we want to measure the current we have to place a low
resistance path in the circuit which energies the coil and
shows the actual current flow.
| Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
IAM COLOR BLIND WHAT IS ELEGIBILITY FOR JUNIOR EXECUTIVE (ELECTRONICS)MEDICAL
Can a transistor be obtained by connecting tow semiconductor diodes back-to-back?
Explain why normally control terminal of 555 timer is connected to ground through a 0.01µf bypass capacitor?
how many type of network protocol
What is schottky diode?
Derive the expressions for average output voltage and rms output voltage of 1φ semi converter?
Explain the Proportionates of Ordinary concrete,Standard concrete,High Stength Concrete of Grades "M10,M15,M20" , "M25,M30,M35,M40,M45,M50,M55" , "M60,M65,M70,M75,M80" Respectively.
why we don't use photodiode in forward-bias?
how much power is required for a 200 watts bulb if 60p/unit is observed?
Explain why a voltmeter should be of very high resistance?
Although zener diode is operated in the reverse breakdown region, but it does not burn. Why?
What is meant by trc?
what are control system components?
hello, i have applied for PO Post.i m so confuse about ques.which type of question u wil ak in interview. i m engg. in electronics & comm. plz tel me
send me few previous years section engineer question papers?..
