kindly tell me how the load on generator increase by just
increasing the fuel of prime mover, as if for exampple 20
MW gen set is synchronized the load ramps from zero to 20
MW gradully and during this procress only fuel of prime
mover increases. Which thing determines the load on
generator with respect to fuel
Answer Posted / nagesh
GOVERNOR IN THE FUEL PUMP DETERMINES THE LOAD OF THE ENGINE
WITH RESPECT TO SPPED OF THE ROTOR.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
how power is generated,and transmitted to our home..pls explain briefly in simple words.
Initially, when the input is not equal to the output — what type of response is this?
how to find the multiplication factor for digital energy meter and analog energy meter
Cb closed condition if there is a tcs fail whether cb will trip or not
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
control & auxilary circuits used for circuir breakers
How many types oil using in transformer ? How many letars using in transformer..?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
How to maintain ac plant?
HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm