Answer Posted / amit kumar
Becoz we cant store the ac supply and at the time of fault
we need fast tripping of the coil, which can be done by dc
only.
Is This Answer Correct ? | 38 Yes | 5 No |
Post New Answer View All Answers
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
How to calculate loses in transformer of 160 KVA ?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what is the mechanical safety of DG ?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
bus bar design conditions and sizing pls tell me quickly
How capacitor improves pf
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
what is the breaking capacity and making capacity of circuit breaker and how
What is Traction? 1KVA Alternator, How much urrent taken?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
what about GD square and its important for motor design?