IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR
THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE
INDIVIDUAL SHAFT FOR EACH TURBINE....?
Answer Posted / phani
however 3 turbines are having individual shafts only.
may be in some designs HP & IP are in single shaft and LP
only in another shaft for 110 MW BHEL design.
For any 500MW, All 3 turbines are coupled with individual
shafts only.
this concept is bases on Torque and Steam pressure.
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
How oxygen can be removed from steel during melting? What are fully killed steels ?
What are the causes of damage of diesel engine exhaust Valve?
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
What is meant by laminar flow ?
Crankcase oil mist detector
How convective heat transfer is effected and on what factors it depends ?
What is a slined joint?
Hello sir I am going to give section engineer examination and will be held in 2010. So I need all prevous years examination papers. please send it on my email id : bhalchandrap@yahoo.co.in
There is a back compression in Engine, what does it mean
Define representative elementary volume?
How cooling Tower height selected
What is gtsc technology?
What kind of pipes are used for steam lines?
What is comprehensive definition of compressor surging
Explain the difference between the flight of a plane and a helicopter?