Interested to Buy Any Domain ? << Click Here >> for more details...
How can w select the cable size for different rating load
& also waht r factors affecting the during selection of
cable?
- 11 Answers
- 37696 Views
- AB Inc, Bosch, BRB Cable, Lucas TVS, Trisome Technical Services, I also Faced
- E-Mail Answers
Answer Posted / nilkanth
Cable size depend upon the full load current rating.Suppose
current rating is 86A then csble size is 35 SQMM.The
factores are the cunductor size and used cunductor
| Is This Answer Correct ? | 54 Yes | 41 No |
Post New Answer View All Answers
why co incidence factor considered in transformer sizing?
What is the difference between line drop and percentage line drop?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
Did RMU have ct and pt ?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What are the disadvantages of hydropower?
what is earth pit , how we can measured it, what earth rods reference
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
What is difference between Harmonic and Non harmonic Capacitor Bank?
describe the phenomena of vacuum interruption in C.B
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
