Interested to Buy Any Domain ? << Click Here >> for more details...
Input power is 380 - 450 V but with 45 - 55 Hz frequency -
desired output is 415 V and 50hz with 1% variation
permissible. CVT / Servo dont stabilize the Frequency -
what is best solution??
- 7 Answers
- 11244 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / vikramsenareddy
please arrange AVR( autometic voltage regulator)
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What are your future plans for the company if permanently employed?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Tell me all plants load factors i.e which plant operating on which load?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
can i use 2000/5A Clamp meter to measure HT cable
Is it possible to connect a safety device in to parallel?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
What are the different sign conventions used in electric circuits?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What is the use for cable entry in control room?
What is making & breaking current ???
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
