Interested to Buy Any Domain ? << Click Here >> for more details...
if HT side voltage is high current is low . and LT side
voltage is low current is high please explian.
- 5 Answers
- 23760 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / asutosh
for a perticular design the incoming power is same.
we know P = VI so when voltage is high current is low &
viceversa.
| Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
what is the safety of voltage power transformer(2250KVA0
What is the difference between cylindrical-type and sandwich-type winding?
Why does the radius of armature is less than the radius of pole shoe?
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
how we calculate the dick for a pole?
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
What are the factors influence the choice of an electrc drive?
WHAT IS MEANT BY DERATING OF THYRISTOR?
What happens if i apply 500V to 440V rotary Switch ?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
how does it help for selection of a transformer.
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
What is the type of feedback used in an op- amp schmitt trigger?
