why 4-20 mA signal is preferred over a 0-10V signal
Answer Posted / akg d gr8
Voltage drops due to Resistance and so we are using 4-20 mA
| Is This Answer Correct ? | 77 Yes | 11 No |
Post New Answer View All Answers
In Safe Guarding test what means by "Failed to Danger" ?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How to calibrate Toxic gas detector?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
If P will increase then what will happen with PID?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
What is PDS and PDMS ?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
Difference between ultra sonic flow meter
How does your previous experience relate to the job you are applying for ?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?