Interested to Buy Any Domain ? << Click Here >> for more details...
why synchronization done in clockwise direction?
- 12 Answers
- 25550 Views
- Hindalco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / amritpal singh sidhu
I think this is due to the phase sequence, because we use
the sine wave in electrical generation so the sine wave
produced is according to quadrants(In which sine wave is
plotted CLOCKWISE ).
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What is power factor why we should maintain the power factor unless what will happen
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
should %impedance be high or low in a power transformer? if so why?
what is interpose? where it is used and why it is used?
some basic standard questions on transformer.
how technical is calculated in 11kv line and lt line
what is the practical application of full adder circuit?
why capacitive load is not used in routine life????any reason is there ??????
full form of electrical?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
What is meant by sag?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
how point on wave controller works.
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
