Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bipin padhy
The base pressure can be calculated and it must be less
than the bearing capacity of soil. Based on the bearing
capacity of soil, the depth of foundation is decided in
case of general structures except for river bridges. But
one has to be careful about the strata below the founding
level. For river bridges, the founding depth decision is
tricky and normally two metres below the calculated scour
depth provided the strata has the bearing capacity more
than the base pressure.Raft foundation or box cell is not
preferred where the velocity of flow is more than
1.5m/sec. In case of shallow foundation including raft, the
length of rigid apron and cut off wall requires to be
determined carefully.
| Is This Answer Correct ? | 10 Yes | 24 No |
Post New Answer View All Answers
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
what is the difference between natural draught cooling tower and induced draught cooling tower
How much quantity of cement Bag for block masonry (1:4) for 1 cu.m? Block size (150x200x400) Mortar Thickness 20mm
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
Technical Question of Civil Engineering
What is the difference between linear dimension and aligned dimension?
1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
what is the formula to find the diagonal shape stirrups?
HOE TO YOU PLAN TO ACCHIEVE THE GOALS?
Can we use concrete of slump cone in cube casting in which we have already measured slump?
Why are steel plates inserted inside bearings in elastomeric bearings?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
What is need for setting limits?
it is possiblee to produce concrete with out cracks...
Draw the cross section of a boundary wall and label its part with detailing?
