Interested to Buy Any Domain ? << Click Here >> for more details...
if AVR fails in alternator. what will be the effect.
- 13 Answers
- 28962 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / satya dev ( knight frank)
The function of AVR in the Alternator is to controlled the
Alternator's voltage by controlling the excitation voltage
of stator, if The AVR fails on Load the voltage will be
reduced to zerro.
| Is This Answer Correct ? | 16 Yes | 22 No |
Post New Answer View All Answers
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
How can calculate the rating of a servo stabilizer for given a specific load
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what is meant by twilight switches 7 where its applicable ?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
how to calculate the torque of a motor?
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
what is servo motor and how it works?
How much of the total hydro power potential has been exploited so far in india?
What is inductance?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
give single line diagram of D.G distribution form alternator to main L.T panel?
What is the principal of motor?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
