i have 28/32 MVA power transformer with 11/6.6 KC voltage
rating and 12%impedance.it have star connection at both
side.but it have another thied winding tertiary
winding.what is used of this winding.
pl tell me
Answer Posted / manish jauhari
Any unbalanced loads, results in increased cirulating
current with in tertiary Delta winding, thereby keepinng
pri & sec voltages with in limits.
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how to select proper cable for ct wiring so that drop within the limit.
11 kv input, 66 kv input advantages
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
describe the fully control circuit diagram of ac drives
What is the power factor of an alternator at no load?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
how to design the heater in temperature control unit to heat 50KL of water?
what is counter poise conductors
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
How are load losses and no-load losses measured at site in a DG set?
Name of the relay of low lub oil presuure in DG sets
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
i want some interview related questions with their answers which can help for attend the interviews...