Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between megger and earth tester?
- 28 Answers
- 106473 Views
- Ashok Leyland, IOCL, RRL, I also Faced
- E-Mail Answers
Answer Posted / harish
Megger is used for measuring an insulation resistance of
motor winding of cable etc. which is measured in megaohm.
While earth tester has earth electrodes which are used to
measure eathpit resistance & it is measured in ohm.
| Is This Answer Correct ? | 139 Yes | 8 No |
Post New Answer View All Answers
Do you know what is dry-out test in x'mer
working principles of cf lamp,incandescentlamp and f lamp?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
Draw a block diagramof Three UPS systems connected in Parallel mode?
what is the difference betweem star connected motor & delta connected motor?
pls,send the previous year written test questions.
why do we not use equivalent voltage source in negative sequence equivalent ckt.
what is mean by restructuring power system?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
can someone explain that how the speed of the protection system affects the fault level calculation?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
