Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if the secondary of current transformer
kept open....
- 16 Answers
- 35257 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / gowtham
FRNDS,
ANSWER 1. INRUSH CURRENT IS NOTHING BUT THE CURRENT
PRODUCED DUE TO THE INDUCED EMF IN THE SEC WINDING. FOR
EXAMPLE IF AT ALL IM USING A 100/5 CT IT IS OBVIOUS THAT
THE INRUSH CURRENT WILL BE VERY LOW COMPARE TO PRIMARY...
ANSWER 2. FRND I KNOW THAT SAFETY ISSUE WILL COME...WHAT IS
IT.THATS MY QUESTION...
| Is This Answer Correct ? | 1 Yes | 9 No |
Post New Answer View All Answers
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
What is the Surge suppresor? Why using in a UDB's and How it works?
what is droop control?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
a governer in an Ic engine controls the
What is the meaning of C1, C61, C91 cable
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
why ct ,cvt should be stored in a vertical position?
working principles of cf lamp,incandescentlamp and f lamp?
What is electrical diversity factor in electrical installations?
