Answer Posted / kalirajan.n
Inrush current or input surge current refers to the maximum,
instantaneous input current drawn by an electrical device
when first turned on. For example, incandescent light bulbs
have high inrush currents until their filaments warm up and
their resistance increases. Alternating current electric
motors and transformers may draw several times their normal
full-load current when first energized, for a few cycles of
the input waveform. Power converters also feature high
inrush currents relative to their steady state currents
Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
what is resver in electrical enginnering with answer
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
Can anyone explain me about the capacitor calculation
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
What is nichols chart?
How to test Alternator stability test for REF relay
How to detect voltage vector shifting in interconnection protection.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
describe the phenomena of vacuum interruption in C.B
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
The simple way of finding the leakage quantity and % in compressed air distribution system
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??