what will happen if the secondary of current transformer
kept open....

Answer Posted / manfred

The C.T will explode due to the Inrush Current flowing
through the secondary Windings of the C.T

Is This Answer Correct ?    6 Yes 25 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.

641


Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?

1036


A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.

1469


What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?

1629


what is strip power factor?

1646






I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.

1933


The windings of a transformer are divided into several coils, because?

819


How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.

1044


how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?

596


Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity

1392


how to increase or decrease speed in DC shunt motor by DC convertor

1729


What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?

994


An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

1415


how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me

970


describe the fully control circuit diagram of ac drives

1370