Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the 3ph capacitor is good or not.
- 14 Answers
- 58925 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / selvan
3phase capacitor connected in the line,power factor
indicate the capacitor good or not.Otherwise check with
volt meter.
| Is This Answer Correct ? | 15 Yes | 16 No |
Post New Answer View All Answers
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
how to calculate fuse rating for a motor
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
When MICC cables used ?
please send me the L&T Emb. sys. placement papers and entire details of pattren
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
which is better to use svc or synchronous condenser why ?
what is the effect of higher value of GD???
What are the electrical engineer roles and responsibilities in chemical plant?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Why strting torqe high in inducation motor?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
