Which of the following device is designed for an AGP slot?
a. HDD
b. Serial Port
c. Video card
d. External Storage Device
What has occurred when HDD fails, making a grinding noise?
a. controller failure
b. the read/ write head is in contact with the platter
c. hard drive is in power save
d. hard drive is in labor
which type of connector is used by analog modems?
a. AUI
b. BNC
c. RJ-11
d. RJ-45
From which control panel option in Windows 95 can u create
a startup disk?
a. system
b. admin
c. add/remove programs
d. network
our customer has bought a second hard disk and added it an
existing computer. The first hard disk is having one
primary partition and extended partition. The extended
partition is divided into two logical drivers D and E. when
you install the second hard drive and format it, what would
be the drive letter assigned to the first logical drive on
the extended partition of hard disk? Assume that the second
hard disk has one primary partition and only one logical
drive on the extended partition.
a. “D”
b. “E”
c. “F”
d. “F”
Which port can the keyboard be connected to?
a. parallel port
b. VGA port
c. PS\2
d. IEEE 1394
You get a CMOS checksum error upon boot. What is the most
likely cause?
a. power supply failure
b. BIOS need to be updated
c. CMOS battery is nearing end of life
d. HDD types are incorrectly defined
You rare reported that the monitor at a client’s place is
having a problem. You are about to remove the CPU tower to
trouble shoot the issue. What do you do just before opening
the CPU tower?
a. wear wrist strap to prevent ESD damage to the monitor
b. Make sure that the power is switched off and the power
cord is plugged out.
c. Make sure that the ESD is grounded properly
d. Connect the monitor as well as the wrist strap to the
ground.
Which of the following files is NOT required for DOS to
boot?
a. COMMAND.COM
b. MSDOS.SYS
c. IO.SYS
d. AUTOEXEC.BAT
Answer Posted / nayeemunisha
Which of the following device is designed for an AGP slot?
c. Video card
What has occurred when HDD fails, making a grinding noise?
b. the read/ write head is in contact with the platter
which type of connector is used by analog modems?
c. RJ-11
From which control panel option in Windows 95 can u create
a. system
our customer has bought a second hard disk and added it an
existing computer. The first hard disk is having one
primary partition and extended partition. The extended
partition is divided into two logical drivers D and E. when
you install the second hard drive and format it, what would
be the drive letter assigned to the first logical drive on
the extended partition of hard disk? Assume that the second
hard disk has one primary partition and only one logical
drive on the extended partition.
c. “F”
d. “F”
Which port can the keyboard be connected to?
c. PS\2
You get a CMOS checksum error upon boot. What is the most
likely cause?
c. CMOS battery is nearing end of life
You rare reported that the monitor at a client’s place is
having a problem. You are about to remove the CPU tower to
trouble shoot the issue. What do you do just before opening
the CPU tower?
b. Make sure that the power is switched off and the power
cord is plugged out.
Which of the following files is NOT required for DOS to
boot?
d. AUTOEXEC.BAT
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How the analysis of departed customer help your organization?
when i went to convergys then i was asked to these question? only for technical post 1. give me your introduction 2. what is ping, ms config, safe mode, last known configuration, system restore, backup, ip address and what is command prompt.....
describe briefly your standards for success?
what are some aspects of your present or most recent position that you like?
please describe your daily routine of your mom
which type questions ask me in call centerin tatasky?
If you had power'what you would had to do with it?
An i m attending dell company interview bt i m rejected in tat last manager round.....they will asked our company h.r u come tis interview after 3 months my 3 months period is over so i should attend for this company interview again...how will get my job pls help me....
how fast can you learn things?
Tell about your work experience. Why you quit that job?
what is good intro,job profle,why you change your perious job,
list three of your most important accomlishment
How do you prioritize the most important things over the least one?
What part of BPO do you like and dislike?
What according to you is a job like at a call center?