Interested to Buy Any Domain ? << Click Here >> for more details...
can we load Power capicitors on DG sets?
- 14 Answers
- 22105 Views
- Neptune, Nimbus, Westin, I also Faced
- E-Mail Answers
Answer Posted / jigar shah
Capacitor requirement arises to effective utilization of
the generated power (to reduce the losses mainly-cu losses
& line losses) & all switchgear component.In general
practice Capacitors are not connected on DG Set.As per my
understanding following are the main reasons for which it
is not recommendation to run capacitors on DG set :
1. During no load condition capacitor will try to increase
the voltage level of genrated voltage which can damage the
insulation of wdg & wdg may get burnt
2. With increase in PF we will not ge much advantage as the
cable losses are negligle.Load is in nearest proximity of
the Equipment.
3. Capacitors can be installed at load side
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
What types domain of laplace transforms? What behavior can laplace transform predict how the system work?
wat system call?
What is the fault or needs to be done when frequency in ac drives is not changing?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
why generator efficiency is more in swinburnes test?
What is lifting power for 1 wb/m2 and 1 A magnet?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
what is the formula of starting current of 3phase and 1 phase motor???
can we conduct the swineburne's test on a dc series motor? why?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
which network topology offers the greatest level of tolerance?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
