Answer Posted / manoj jha

We can use the step-down tansformer as step-up transformer.
Secondary of the Transformer can be used as Primary. I am
using it since last five years. I have no problem. Our
Transformer was Step-Down , 2400/440V which was ordered by
mistake. Actually we were in need of 440/2400V. So we
connected the same Step down transformer as step-up
transformer and it's working pefect.

Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.

2185

---

What is miller crystal oscillator? Explain its operation?

1113

---

What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?

2165

---

What is transister define the transister ammiter ,base, colector.

2223

---

What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.

1671

---

if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)

1843

---

Usage of flywheel diode in relays

1928

---

i want wipro vlsi placement pattern please send me

1778

---

how to find three phase complex power in per unit and MVA?

2199

---

How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?

2607

---

what is thresold of perception

2077

---

Explain the term parallel path in dc machin ?

2212

---

What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.

2006

---

How would you calculate power loss in a resistor?

1077

---

diff b/w normal grounding and resistance grounding

1941

---