What is the difference between "Earthing" and "Neutral"?
- 10 Answers
- 13165 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / thinesh
EARTHING IS TO PREVENT FROM SHOCK
THE JUNCTION OF THE 3 PHASE IS CALLED NEUTRAL
| Is This Answer Correct ? | 4 Yes | 15 No |
Post New Answer View All Answers
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
What are the main faults of DC generators?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
Why Ac Systems Are Preferred Over Dc Systems?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
Classify milling machines.
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
How I calculate the ELCB for circuit breakers?
An automatic water heater is an example of which type of control system?
why star point of HT motor not earthed?
what is the clear formula to calculate cable size for a load
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
how could we know the size of cable by physical view?
