Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
Answer Posted / engr. abdul barek, electrical
We use in star connection in seconday connection becouse
need neutal point in load sied( some load supply need 3
phase and some need single phase)but it is remember that
only star connection use in distrubution side transformer.
Is This Answer Correct ? | 82 Yes | 30 No |
Post New Answer View All Answers
model question paper for supervisor trainee
What is Anemometer used to measure?
How to assume answer to electrical questions
WHY RATING OF VCB NOT LESS THAN 630A
What current flows in the transformer primary when its secondary is open?
The synchronous machine excitation system explain
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
Why High voltage are generate noise ?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
How to Calculate The sag of OPGW in Transmission Line???
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
Why are lt windings placed near the core?
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?